Hello,
Thank you for your message.
In order to keep my 6.10 settings on the existing hosts (especially whether internet-id is enabled or not and, if it is enabled, to keep the same Remote ID) I've created an MSI using the online configurator on which I've basically skipped settings creation.
You want to update some of your current 6.10 Hosts to the latest 7.0.0.3 version but keep all of their previous settings except for the preferred language, correct? In this case, when configuring the MSI package, on
Step 4 - Host settings configuration select the
Pre-configure radio-button and enable the
General and network settings checkbox - this will invoke the Host Settings window where you can navigate to the
Language tab and select
Greek language. This way any remote Host you update using this MSI package keeps its previous settings - only the version and Host language are updated.
I see that the newest host supports the Greek language as well (I'll open a different thread for some notes on that one) which is great! However, since the new MSI uses the old settings, the host is run in English.
In case if you configure your MSI package using version 7.0.0.3 of Viewer, then in the Host Settings you should be able to select the Greek language for Host as described above. In this case, Host is updated to the latest version 7.0.0.3 and is switched to Greek language, all other settings stays intact, so you can apply this MSI package to any group of your remote Hosts.
And the MSI wizard does not allow me to modify only a single property.
Could you please let me know what happens if you try to modify only language during the configuration process? I've just tried creating a standard MSI package with the only setting that switches Host to the Greek language and was able to update my Host settings successfully. Perhaps, you're configuring a One-Click installer or do you receive any error messages in this case?
Hope that helps.