Community

I've created a one-click custom executable, having enabled IPv6 in the settings. If I understand correctly, it allows IPv6 traffic in addition to IPv4. If not, then the following is a feature and not a bug, no need to fix anything.

I've installed this on a system on a LAN that has both IPv4 and IPv6 enabled. I can connect to the host just fine with Internet-ID. I can also connect to it using a fe80 IPv6 address. I can't connect to it using IPv4, even though I see that a listener does exist on 5650/tcp4.

Can you try to reproduce this?

Polina Krasnoborceva wrote:
Could you please let me know if you're able to establish a connection using the IPv4 address to the Host when the  Use IPv6  checkbox is  disabled ?

No, it did not change anything. I could see that there was an IPv4 listener but I could not connect.

In addition, please clarify if you have selected the Use IPv6 checkbox in the Host Settings -> Network -> Port tab only or if the checkbox is also ticked in the following location:
Right-click on the connection in the main Viewer window and select  Connection Properties , navigate to the  Network  tab:
   
If this checkbox is not selected, please try to enable it and see if the issue persists.

I have uninstalled the one-click host which had IPv6 enabled, sorry. Initially it was enabled in both places. I could not connect via ipv4. I deselected it and still couldn't connect...

Good morning,

perhaps you should try to recreate the issue:

* Install viewer in a LAN that has both IPv4 and v6
* Create a one-click host using the online configurator and check use IPv6
* Install this host in the same LAN
* Connect to the system directly over IPv6, should work
* Try to connect to system directly over IPv4, does it work?