Klaus Pracht's community posts

Hello Polina,
Finally, after I found out that I can change the language in the Settings (sorry! Blinded by features ;-) ), I tried the whole thing with different languages. I can tell, that this is a bug like you already mentioned above. This concernes not only German, but also Dutch, French an others (I didn't test'em all).
When I switch to English, I can properly set Blacklist and Whitelist in the IP-Filter settings and the settings remain properly set after switching back to the language i want, i.e. German.
Every new IP-Filter settings I make in another language than English, go wrong and end up as Blacklist-Entry.
So at least we found a workaround, the rest will be fixed, I assume ...
Kindest regards and many thanks for helping out,
Klaus

Hello Polina,
I tried exactly to your description to enter a whitelist in V. 6.10.xx and V 6.12Beta4.
It is identical in both versions. I cannot distinguish between "Whitelist" and "Blacklist"-tab no matter if ich sel ect "Allow everyone, except" or "Deny everyone, except". I installed on 4 different machines now, always the same result! Every IP-address or IP-range ends up in "Allow everyone, ..."
I also tried to install an english version of the host, but I always end up with a german version.
And that seems to the point of it. It seems to be a language problem!
The two tabs for "Blacklist" and "Whitelist" are not klickable, as you can see on my screenshot. Instead, there is just the text and a "\n ;" between "Blacklist" and "White list", "Blacklist" is not seperated by a space, like in your screenshot.

To me, this whole issue look like a bug in the german version ...
Like I said, I installed the host on different machines, new and older Win10pro-installlations, all the same.
Looking forward to hearing fr om you,
Kindest, Klaus

sorry, misstyped the Version I use. Its not 6.2 but 6.10.10 as you can tell from the screenshots ...

I am using V 6.20
Hello there!
I have a problem setting up a whitelist-filter.
When I try to set up whitelist-entrys within "IP-Filter" and save them, these entries are only visible, when I switch to "Blacklist". When I select "Whitelist" again, the entries disappear, are not visible. Any entries I make ar only visible, when "Blacklist" ist select. (I'm calling the selectors "Blacklist" and "Whitelist", because I am using the german version and don't know how they are called in the english version).
Question: Is this a bug or are the IP-entries still working as "Whitelist"-entries, despite being invisible (access only for the defined entries)? I cannot test it, without setting up a test-environment, which causes a lot of work ...
Kindest regards, Klaus