Community

Remote Utilities Viewer for Mac andLinux has been released. Send us your feedback and report bugs in this discussion thread.

Version 6.5 BETA

steve godfrey, User (Posts: 4)

Oct 18, 2016 6:56:17 am EDT

Hi Conrad
sorry the reply was meant for you not ashley ??
no joy with ctrl alt del
does this command actually work with just agent installed on the remote pc ?
ideally I did not want host just the agent installed ?
regards
Steve

Version 6.5 BETA

steve godfrey, User (Posts: 4)

Oct 18, 2016 6:18:28 am EDT

Hi Ashley
Have tried all ways it just will not work ?
tool bar shows I have full control
tried both beta and stable 6.3
it just doesnt work
regards
Steve

Version 6.5 BETA

steve godfrey, User (Posts: 4)

Oct 17, 2016 5:57:12 pm EDT

Hi thanks for your reply
I finally got the logo sorted it appears that somehow if older viewers had been previously installed somehow when I upgraded to the new beta it seemed to have interfered with this process somehow ?
I completely removed all including registry reinstalled the beta and it now works fine.
Also have remote reboot up and running.

However found that I am unable to run the ctrl alt delete command ? have checked that I am in full control mode but no shortcut key functions seem to operate not sure what I am doing wrong here as instructions seem pretty straight forward ? could it be my customized agent / access rights perhaps ? have seen the post on domain issue fix but that is not the case here.

regards
Steve
Edited:steve godfrey - Oct 17, 2016 7:39:40 pm EDT

Version 6.5 BETA

steve godfrey, User (Posts: 4)

Oct 17, 2016 7:17:10 am EDT

Hi everyone
Is it just me ?
tried to use the msi configurator in the new viewer beta and I seem unable to make my logo stick ?
when it creates the new agent exe my logo is missing ?
have been able to do this with the final edition no problem.

Also try as I may not been successful with using the run after reboot either ?
it works but always get the UAC prompt ( meaning it requires a manual acceptance as the agent runs) no matter what i have tried with security settings / permissions etc.
the only way have found around this so far is just to switch UAC off on the computer using the agent
thanks in advance for any replies
regards
Edited:steve godfrey - Oct 17, 2016 7:25:10 am EDT
This website uses cookies to improve user experience. By using this website you agree to our Terms of Service and Privacy Policy.